Two-Jaw Gear Pullers
- Two-jaw gear puller for drawing gears, pulleys and bearings off shafts without hammering or damaging parts.
- Seven sizes from 3 inch to 12 inch, with printed jaw spread from 40 to 75mm up to 120 to 300mm.
- Maximum ratings from 2 tons on the 3 inch puller up to 15 tons on the 12 inch puller.
- Made of Chrome Vanadium Steel, a strong alloy for tools that carry heavy pulling loads.
- Two-jaw design slips into narrow spaces behind a part where a three-jaw puller will not fit.
Available Sizes (7) Show all 7 sizes Hide sizes
Genius Tools Two-Jaw Gear Pullers
Genius Tools Two-Jaw Gear Pullers remove press-fit parts the controlled way. The jaws hook behind a gear, pulley, bearing or wheel hub, and turning the center forcing screw against the shaft end draws the part straight off.
This puller is made of Chrome Vanadium Steel, the material printed for the series in the catalog, so the jaws, yoke and screw stand up to the high forces involved in pulling seized components.
Seven sizes are offered: 3, 4, 5, 6, 8, 10 and 12 inch. Capacity grows with size, with printed jaw spreads (A1 and A2) from 40 to 75mm on the 3 inch puller up to 120 to 300mm on the 12 inch, and maximum ratings of 2, 4, 5, 6, 10, 12 and 15 tons respectively.
Choose the two-jaw style when space is tight or when the part only offers two good gripping points. Pick a size whose spread comfortably covers the part diameter and whose reach clears its depth, and you will get a straight, even pull.
- Type: two-jaw gear puller
- Sizes: 3 inch to 12 inch (7 sizes)
- Jaw spread: 40-75mm up to 120-300mm
- Max. rating: 2 to 15 tons
- Material: Chrome Vanadium Steel
| Type | Pullers |
|---|
