Three-Jaw Gear Pullers
- Three-jaw gear puller that grips a part at three points for a balanced, centered pull off the shaft.
- Seven sizes from 3 inch to 12 inch, with printed jaw spread from 40 to 75mm up to 120 to 300mm.
- Higher ratings than the matching two-jaw pullers, from 3 tons up to 22 tons on the 12 inch size.
- Made of Chrome Vanadium Steel, giving the jaws and forcing screw strength for heavy pulling work.
- Three points of contact reduce the risk of the part tilting or the jaws slipping off during the pull.
Available Sizes (7) Show all 7 sizes Hide sizes
Genius Tools Three-Jaw Gear Pullers
Genius Tools Three-Jaw Gear Pullers are built for steady, even removal of gears, bearings, pulleys and hubs. Three jaws spaced around the part share the load, keeping the pull centered on the shaft so the part comes off straight.
The catalog prints Chrome Vanadium Steel as the material for this series. That alloy gives the puller the strength to work against stubborn, rusted or tightly pressed parts.
Seven sizes are offered, 3, 4, 5, 6, 8, 10 and 12 inch, with the same printed jaw spreads as the two-jaw series, from 40 to 75mm up to 120 to 300mm. Because the load is shared by three jaws, the maximum ratings are higher: 3, 6, 7.5, 9, 15, 18 and 22 tons.
Choose a three-jaw puller whenever there is room around the part. It is the steadier option for round components such as bearings and pulleys in automotive, agricultural and industrial maintenance.
- Type: three-jaw gear puller
- Sizes: 3 inch to 12 inch (7 sizes)
- Jaw spread: 40-75mm up to 120-300mm
- Max. rating: 3 to 22 tons
- Material: Chrome Vanadium Steel
| Type | Pullers |
|---|
