T-Handles (Ball Joint) 1/2" Dr.
- Ball-joint T-handles for 1/2 inch drive sockets give two-handed turning force with an angled reach at the drive end.
- Two lengths are available: 350mm (item 423504T) and 500mm (item 425004T) for normal and deep reach.
- The ball joint lets the socket tilt to meet fasteners that are not straight in line with the handle.
- Larger 1/2 inch drive makes these T-handles suited to bigger sockets and heavier fasteners than the 3/8 inch versions.
- Made of Chrome Vanadium Steel, as printed on the Genius Tools 1/2 inch drive accessory page.
Available Lengths (2) Show all 2 lengths Hide lengths
-
Length 350mm
$22.19
-
Length 500mm
$28.91
Genius Tools T-Handles (Ball Joint) 1/2" Dr.
Genius Tools T-Handles (Ball Joint) 1/2 inch Dr. are T-shaped drivers with a ball joint at the square drive. Holding the cross bar with both hands gives even, controlled force, while the ball joint lets the socket sit at an angle to the shaft so you can reach fasteners around obstructions.
The series offers two lengths. The 350mm handle suits general vehicle and equipment work, while the 500mm handle reaches deeper into engine compartments, frames and machinery.
T-handles are fast for running nuts along long threads and for jobs with many repeated fasteners. With a 1/2 inch drive, these handles accept the larger sockets used on heavier hardware.
Both lengths are made of Chrome Vanadium Steel and work with all 1/2 inch drive sockets. Keep the 350mm handle for everyday reach and the 500mm handle for deeper jobs, so you can turn fasteners at an angle comfortably without building a stack of extensions and joints.
- Type: T-handle with ball joint drive
- Drive: 1/2" square
- Lengths: 350mm, 500mm
- Material: Chrome Vanadium Steel
| Type | Accessories |
|---|
