Metric & SAE Wobble Hex Head Drivers
This Item has limited quantity. Request Quote for item availability.
- Wobble hex tip lets the driver engage an internal hex screw at a slight angle when you cannot line up straight.
- Twenty sizes in one series: ten metric sizes from 4mm to 19mm and ten SAE sizes from 3/16 inch to 3/4 inch.
- Metric sizes are the same 1/2 inch drive wobble hex head drivers packed in the WH-410MD set listed on the catalog page.
- Each driver is 76mm long, with a socket body of 24mm, 26mm or 28mm depending on the hex size.
- Drive hex screws with a ratchet for more controlled torque than an L-key, even around obstacles that block a straight approach.
Available Sizes (20) Show all 20 sizes Hide sizes
- Size 4mm Out of stock Sold out
- Size 3/16" Out of stock Sold out
- Size 5mm Out of stock Sold out
- Size 6mm Out of stock Sold out
- Size 1/4" Out of stock Sold out
- Size 7mm Out of stock Sold out
- Size 5/16" Out of stock Sold out
- Size 8mm Out of stock Sold out
- Size 3/8" Out of stock Sold out
- Size 10mm Out of stock Sold out
- Size 7/16" Out of stock Sold out
- Size 12mm Out of stock Sold out
- Size 1/2" Out of stock Sold out
- Size 14mm Out of stock Sold out
- Size 9/16" Out of stock Sold out
- Size 5/8" Out of stock Sold out
- Size 17mm Out of stock Sold out
- Size 11/16" Out of stock Sold out
- Size 19mm Out of stock Sold out
- Size 3/4" Out of stock Sold out
Genius Tools Metric & SAE Wobble Hex Head Drivers
Genius Tools Metric & SAE Wobble Hex Head Drivers are made for internal hex fasteners that sit where a straight tool will not line up, such as screws behind brackets, next to housings or deep in an engine bay. The wobble tip lets the driver work at a slight angle, so you can still turn the screw with a ratchet.
The series offers both measuring systems. Metric sizes are 4, 5, 6, 7, 8, 10, 12, 14, 17 and 19mm, and these are the 1/2 inch drive wobble hex head drivers found in the WH-410MD set. SAE sizes run 3/16, 1/4, 5/16, 3/8, 7/16, 1/2, 9/16, 5/8, 11/16 and 3/4 inch.
All twenty drivers measure 76mm overall. The body diameter is 24mm on the smaller sizes and steps up to 26mm and then 28mm as the hex gets bigger, so check the space around the fastener if clearance is tight.
Choose single sizes to fill gaps in your kit, or mix metric and SAE drivers if you service both kinds of equipment.
- Type: wobble hex head driver
- Metric sizes: 4mm - 19mm (10 sizes)
- SAE sizes: 3/16" - 3/4" (10 sizes)
- Length: 76mm
- Body diameter: 24mm - 28mm
| Type | Head Drivers |
|---|
