Magnetic Bit Holders 1/4" Hex Shank
- Long magnetic bit holders that hold 1/4 inch hex bits far out ahead of the handle or tool for deep reach.
- Two lengths, 150mm and 250mm, for screws located deep inside machines, engine bays and cabinets.
- The magnetic tip keeps the bit in place and helps hold small screws, reducing dropped parts.
- Works with the Genius Tools range of 1/4 inch hex bits, from slotted and Phillips to star and hex profiles.
- Made of Chrome Vanadium Steel for a stiff shaft that resists bending when reaching hard-to-get fasteners.
Available Lengths (2) Show all 2 lengths Hide lengths
-
Length 150mm
$8.84
-
Length 250mm
$16.06
Genius Tools Magnetic Bit Holders 1/4" Hex Shank
Some screws simply sit too far in for a normal screwdriver. Genius Tools Magnetic Bit Holders put a 1/4 inch hex bit at the end of a long shaft, letting you reach fasteners at the bottom of housings, behind panels and inside equipment.
Two lengths are available: 150mm for moderate reach and 250mm for the deepest jobs. The magnetic tip keeps the bit secure and also helps hold a steel screw on the bit while you guide it into place.
The catalog lists these holders in the GA-015A ratcheting screwdriver accessory set as 1/4 inch drive, 1/4 inch hex shank pieces, so they combine with ratcheting screwdrivers and other drivers in the same system.
Both holders are made of Chrome Vanadium Steel, giving a firm shaft that keeps the bit aligned with the screw. Choose the 150mm holder for everyday reach and keep the 250mm holder for the deepest access holes.
- Type: magnetic bit holder
- Bit fitting: 1/4" hex
- Lengths: 150mm, 250mm
- Material: Chrome Vanadium Steel
| Type | Accessories |
|---|
