Impact Bit Holders (30mm)
- Short 30mm impact bit holders keep hex bits as close as possible to the tool for maximum control in tight spaces.
- Two hex shank sizes are available: 1/4 inch for standard bits and 5/16 inch for larger, heavier bits.
- The shortest bit holder length in this Chrome Molybdenum accessory range, ideal where clearance is very limited.
- Made of Chrome Molybdenum Steel to handle the hammering action of impact tools.
- Lets you drive screws and hex fasteners with the same impact setup you use for sockets.
Available Options (2) Show all 2 options Hide options
- Shank 1/4" Out of stock Sold out
-
Shank 5/16"
$16.33
Genius Tools Impact Bit Holders (30mm)
Genius Tools Impact Bit Holders in the 30mm length are the compact choice in the Chrome Molybdenum impact accessory range. When there is barely room for the tool, a short holder keeps the bit tight to the drive, which helps it stay steady on the screw head.
Two versions are offered. The 1/4 inch hex shank holder takes the common bit size used for most screwdriver and Torx bits, and the 5/16 inch hex shank holder is meant for larger bits used on heavier fasteners. Both share the same 30mm length.
Using a bit holder means one impact setup can handle bolts and screws, reducing tool changes during assembly and repair work. If you also need more reach, the same catalog page lists 39mm and 46mm holders.
The holders are made of Chrome Molybdenum Steel, a tough material suited to impact use. Choose the shank size that fits your bits.
- Type: impact bit holder, short
- Hex shank: 1/4", 5/16"
- Length: 30mm
- Material: Chrome Molybdenum Steel
| Type | Accessories |
|---|
