Hose Clamp Drivers
- Hose clamp driver is a nut driver made for tightening and loosening the hex screws found on worm-drive hose clamps.
- Four hex sizes are available: 6mm, 7mm, 8mm and 10mm to fit the most common hose clamp screw heads.
- Each driver is 280mm long, giving the reach needed to get at clamps deep in engine bays and behind components.
- Faster and more secure than a slotted screwdriver, which can slip out of the clamp screw and damage nearby parts.
- Useful for radiator, heater, coolant, fuel and air intake hoses in automotive, marine and equipment repair.
Available Sizes (4) Show all 4 sizes Hide sizes
Genius Tools Hose Clamp Drivers
Many hose clamps use a small hex-head screw that can be turned with a flat screwdriver, but the blade often slips out of the slot. The Genius Tools Hose Clamp Driver fits over the hex head instead, so it holds the screw securely and lets you tighten or release the clamp quickly and with less effort.
The series is offered in four sizes: 6mm, 7mm, 8mm and 10mm. All of them share a 280mm length, which gives good reach to clamps tucked behind radiators, under intake ducts or deep in crowded engine bays.
Use them on coolant, heater, fuel and air intake hoses, on boats and machinery, or anywhere worm-drive clamps are used. Pick the size that matches your clamps, or keep all four so you are ready for the different clamp sizes that are often found on a single vehicle or machine.
- Type: hose clamp driver
- Sizes: 6mm, 7mm, 8mm, 10mm
- Length: 280mm
| Type | Automotive Tools |
|---|
